Fire Extinguishers

Virtually all fires are small at first and might easily be contained if the correct type of extinguisher is readily available and properly used. Fire extinguishers are the first line of defense against unfriendly fires and should be installed in all homes and businesses.

Selecting the correct extinguisher is important both to insure suitability for the expected type of fire, and to reduce damage to valuables from extinguishing agents. Using the wrong type of extinguisher can needlessly ruin your expensive computer which gets blasted with over spray from a small fire in your office.

Used properly, a portable fire extinguisher can save lives and property by putting out a small fire or containing it until the fire department arrives.

Extinguishers Have Limits

Many household fire extinguishers are “multipurpose” A-B-C models, labeled for use on all three classes of fire. If you are ever faced with a Class A fire and don’t have an extinguisher with an “A” symbol, don’t hesitate to use one with the “B-C” symbol.

EXTINGUISHER SIZES:

Portable extinguishers are also rated for the size of fire they can handle. Normally, an extinguisher that has a rating of 2-A:10-B:C on its label is recommended for each floor level. The larger the number, the larger the fire that the extinguisher can put out. Higher-rated models are often heavier. Make sure you can hold and operate the extinguisher before you buy.

EXTINGUISHING AGENTS:

There are five common groups of extinguishing agents. Choose one which will handle the correct class of fire while keeping damage at a minimum.

Dry Chemical, standard type: Useful on Class B and Class C fires. Leaves a mildly corrosive residue which must be cleaned up immediately to prevent damage to electrical equipment. Best uses are automotive, grease fires and flammable liquids.

Dry Chemical, multipurpose type: Useful for Class A, B and C fires. Versatile and effective on most common types of fires. Highly corrosive and leaves a sticky residue. Not for use around delicate electrical appliances or computers.

Halogenated Agents: Useful on Class A, B and C fires depending on agent used, check label. Expensive but very versatile and clean. Leaves no residue. Mildly toxic. Excellent for delicate computers and electrical equipment. Also good for flammable liquids and automotive use. This is one of the best all around choices for offices, however, environmental restrictions and rising costs limit availability.

Carbon Dioxide: Useful on Class B and Class C fires. Very clean, no residue. Short range, must be applied close to fire.

Water Based Agent: Use on Class A fires only. Inexpensive to refill and maintain.

These are the most common extinguishers in use. Base your selection on the size and classification needed plus compatibility with what you are trying to protect. It is also necessary Water Based Agent: Use on Class A fires only. Inexpensive to refill and maintain.

These are the most common extinguishers in use. Base your selection on the size and classification needed plus compatibility with what you are trying to protect. It is also necessary WARNING: It is very dangerous to use water or an extinguisher labeled only for Class A fires on a grease or electrical fire. The “C” in a rating indicates that you can use the unit on electrical fires.

Installation/Maintenance 

Extinguishers should be installed in plain view, above the reach of small children, near an escape route and away from stoves and heating appliances. Ask you local fire department for advice on the best locations.

Extinguishers require routine care. Read your operator’s manual and ask your dealer how your extinguisher should be inspected and serviced. Rechargeable models must be serviced after every use. Disposable fire extinguishers can be used only once, and must be replaced after use. Following manufacturer’s instructions, check the pressure in your extinguishers once a month.

Remember the PASS-word 

Keep your back to an exit and stand six to eight feet away from the fire. Follow the four-step PASS procedure. If the fire does not begin to go out immediately, leave the are at once.

PULL the pin: This unlocks the operating lever and allows you to discharge the extinguisher. Some extinguishers may have other seals or tamper indicators.

AIM low: Point the extinguisher nozzle (or hose) at the base of the fire.

SQUEEZE the lever above the handle:This discharges the extinguishing agent. Releasing the lever will stop the discharge. (Some extinguishers have a button instead of a lever.)

SWEEP from side to side: Moving carefully toward the fire, keep the extinguisher aimed at the base of the fire and sweep back and forth until the flames appear to be out. Watch the fire area. If the fire re-ignites, repeat the process.

Always be sure the fire department inspects the fire site, even if you think you’ve extinguished the fire.

Should You Fight the Fire?

Before you begin to fight a fire:

* Make sure everyone has left, or is leaving, the building.

* Make sure the fire department has been called.

* Make sure the fire is confined to a small area and is not spreading.

* Be sure you have an unobstructed escaped route to which the fire will not spread.

* Be sure you have read the instructions and that you know how to use the extinguisher.

It is reckless to fight a fire in any other circumstances. Instead, leave immediately and close off the area.